Defining And Editing Order Configurations Of The Combiprint Type; Film Mask; Applies Only To D-Lab.2/2Plus - AgfaPhoto d-lab.2 8060/260 Operation Manual

Settings and Configurations
4.8.3

Defining and Editing Order Configurations of the Combiprint Type

Note
Applies to d-lab.2/2plus
In an existing order configuration the settings for Config. type and for Film mask can
no longer be changed. If you edit an order configuration the Config. type button is
inactive. If you change the setting for the film mask the software will switch from Edit
to New: i.e. in this case you are no longer editing the selected configuration, but you
define a new configuration.
Applies to netlab.2plus
In an existing order configuration the setting for Config. type can no longer be
changed. If you edit an order configuration the Config. type button is inactive.

4.8.3.1 Film Mask: 135, 120, 110

Applies only to d-lab.2/2plus

022_negkp
4-120 2005-05-01 / PN 04092_01
d-lab.2, d-lab.2plus, netlab.2plus: Operation
If the screen Combiprint order
configuration was called up with New:
press Config. type and select Combiprint.
Press Film type and select (Color negative
or BW).
Press PpF (number of prints per frame) and
enter the desired value:
preset value = 1 (range 0 to 999).
Sub-configurations Indexprint, Backprint,
Correction, Autosave, Front print: press
the button and select the respective sub-
configuration from the list or set to Off.
Press Combiprint and select the desired
configuration.
Press Save or Save as and enter the name.
AgfaPhoto