Lane Distributor (Ld): Remove Paper Dust And Deposits - AgfaPhoto d-lab.2 8060/260 Operation Manual

d-lab.2, d-lab.2plus, netlab.2plus: Operation

8.4.4.4 Lane distributor (LD): Remove Paper Dust and Deposits

Applies to d-lab.2
CAUTION!
Danger caused by toothed belts that may run in the marked area: Risk of bruising.
Do not reach into the machine.
Purpose:
To avoid transport problems.
Tools and/or material
– Vacuum cleaner
– Brush
– Isopropanol, (for plastic-coated rollers, not for rubber rollers)
3
dlab2079
AgfaPhoto
2 1
Open the Printer front door.
Unscrew the locking screw (red) (1).
Pull out the lane distributor on the
telescopic rails.
Remove the paper dust with a vacuum
cleaner.
Remove the guide plates after opening the
quick-action locks (2) and the knurled screws
(3).
Clean all guide plates with a damp cloth or
AgfaPhoto Cleaner (see
substances
at the end of this Chapter).
Put back the guide plates:
Make sure that they sit correctly in the
holders and that the quick-action locks are
locked.
Clean the transport rollers with a damp lint-
free cloth.
Push in the lane distributor and tighten the
locking screw (red).
2005-05-01 / PN 04092_01
Maintenance
8
Cleaning
8-19