Printing A Pbl Test; General Procedure - AgfaPhoto d-lab.2 8060/260 Operation Manual

d-lab.2, d-lab.2plus, netlab.2plus: Operation
5.3

Printing a PBL Test

5.3.1

General Procedure

075
097
AgfaPhoto
Press in this order:
Test
Start PBL
The screen PBL for paper configuration opens.
Select the paper configuration for which the
PBL test is to be printed.
Select the paper configuration of which the
laser points should be copied (see
Copying Laser Points during Calibration of a
Paper Configuration
in this chapter).
If you do NOT want to copy the laser points
from another configuration, press the button
Copy laser points from to select the option
OFF (then indicated on the button).
Press PBL.
Note
The input in the menu Settings > Machine
settings > Printer settings > Max. calibr.
Cycles (Maximum number of calibration
cycles) defines how often a PBL should be
repeated automatically if the values are not in
tolerance after the first or further attempts (we
recommend to keep the default value).
The Print PBL screen opens.
Press Emulsion no.
Enter the emulsion number (not compulsory;
only for information, it is not evaluated).
The emulsion number is printed on the paper
bag.
Press Tolerance: step width 0.1 mm
Input option for hand-measured paper width
deviations from the coded width (useful for
border prints)
(step width 0.1 mm).
If necessary press with laser point to
activate or deactivate the function (see
PBL Test with Laser Point
2005-05-01 / PN 04092_01
Tests
5
in this chapter).
5-9