Table of Contents
Advertisement
Troubleshooting
Special case:
A paper jam occurs during shutdown of the machine or during reset.
The paper jam is only reported when the machine is started again: during this time, the
Info function cannot be called up.
7.8.2
Paper Jam in the Printer
Applies to d-lab.2plus/netlab.2plus
Proceed as follows in case of a paper jam in the Printer part:
The sequence control tries to transport all paper out of the Printer and through the
–
paper processor. In case of an actual mechanical problem this is not possible.
All papers, which are past the location of the paper jam in paper transport direction,
–
are still transported and developed.
All prints in the area of the paper jam must be removed. Watch out for small paper
–
remainders.
Assemblies which have to be pulled out of the Printer to remove jammed paper are
–
not energized.
The Printer will automatically be ready for printing once the operator has removed the
–
jammed papers and cleared the error message or triggered a reset.
7-30
2005-05-01 / PN 04092_01
d-lab.2, d-lab.2plus, netlab.2plus: Operation
Input and output of the print machine
PM, sheet distributor and transfer from
sheet distributor to sheet transfer (ST).
Check if paper jam is still reported.
Pull out the sheet transfer (ST).
Check the print drum in the print
machine:
Take out the top guide plate, turn the
print roller forward by hand to transport
out any paper that may still be inside.
AgfaPhoto
Advertisement
Table of Contents
