Defining And Editing Order Configurations Of The Single Type; Film Mask; Applies Only To D-Lab.2/2Plus - AgfaPhoto d-lab.2 8060/260 Operation Manual

Settings and Configurations
4.8.1

Defining and Editing Order Configurations of the Single Type

Note
Applies to d-lab.2/2plus
In an existing order configuration the settings for Config. type and for Film mask can
no longer be changed. If you edit an order configuration the Config. type button is
inactive. If you change the setting for the film mask the software will switch from Edit
to New: i.e. in this case you are no longer editing the selected configuration, but you
define a new configuration.
Applies to netlab.2plus
In an existing order configuration the setting for Config. type can no longer be
changed. If you edit an order configuration the Config. type button is inactive.
Applies to d-lab.2/2plus
The possible settings in the Order configuration screens depend on the selected film
mask. Below they are described for all film carriers available for the machine.

4.8.1.1 Film Mask: 135, 120, 110

Applies only to d-lab.2/2plus

022_negsi
4-112 2005-05-01 / PN 04092_01
d-lab.2, d-lab.2plus, netlab.2plus: Operation
If the Order configuration screen was
called up with New: Press Config. type and
select Single.
Press Film type and select (Color negative
or BW).
Press PpF (number of prints per frame) and
enter the desired value:
preset value = 1 (range 0 to 999).
Sub-configurations (Indexprint, Backprint,
Correction, Autosave, Front print): press
the button and select the respective sub-
configuration from the list or set to Off.
If border prints are to be printed:
Press Border and enter the required
value.
Possible values: 4–60 mm
Presetting: 0 (for borderless).
Press Border color and select the desired
color.
AgfaPhoto