Table of Contents
Advertisement
d-lab.2, d-lab.2plus, netlab.2plus: Operation
Applies only to d-lab.2/2plus
Manual end of order is activated by pressing the End of order button or End of order
after film strip. This is necessary:
In the Manual positioning and Slide print mode.
–
In the Autoprint mode if the function Autom. end of order is inactive (see
–
Settings
in Chapter 4).
In the Autoprint mode if the function Autom. end of order is activated but the film
–
strip to be printed is shorter than defined under Film length (e.g. 4-neg strip) (see
Other Settings
in Chapter 4).
Note
All information needed for pricing is saved whenever an order is terminated.
6.1.9
Special Print Products and Motif Groups
6.1.9.1 Black and White Prints
Black&white prints can be printed
– Applies to d-lab.2/2plus
from black&white films of the sizes 135, 120, 110 (with colored film base and
without),
– Applies to d-lab.2/2plus
from color films of the sizes 135, 120, 110,
from grayscale image files.
–
Original: color negative film
Applies only to d-lab.2/2plus
The selected order configuration must be a configuration for the film type B/W. This
eliminates the colors of color negatives by calculation during the digitizing. The prints are
then black&white. We recommend to set the saturation for strong dominant colors to -9.
Note
Film type B/W is not possible in Reorder. In this case color negatives are printed in
color even if a B/W configuration has been selected.
AgfaPhoto
Other
2005-05-01 / PN 04092_01
Production
6
6-21
Advertisement
Table of Contents
