Defining Paper Width, Surfaces And Cut Lengths; Defining Paper Widths - AgfaPhoto d-lab.2 8060/260 Operation Manual

Settings and Configurations
4.3

Defining Paper Width, Surfaces and Cut Lengths

For the machine to detect which width and surface a paper inserted in the magazines has,
these parameters must first be defined on the machine and set up accordingly on the
paper magazines. The paper magazines are set up by slide switches (see
Magazine Codes
in Chapter 6), the set up in the machine is explained below.
The definition of cut lengths specifies the lengths in which the paper has to be cut.
Widths and surfaces are combined in paper configurations (see
Paper configurations
in this chapter). And in the order configurations these are then
combined with the cut lengths (see
chapter).
4.3.1

Defining Paper Widths

310
4-12 2005-05-01 / PN 04092_01
Defining and Editing Order Configurations
d-lab.2, d-lab.2plus, netlab.2plus: Operation
Paper
Defining and Editing
in this
Call up:
Press in this order:
Settings
Machine settings
Paper settings
The screen Paper settings opens.
If you want to define a new paper width
press New.
If you want to change the code for an
existing paper width, select the desired
paper width (configuration) from the list and
press Edit.
AgfaPhoto