Table of Contents
Advertisement
Settings and Configurations
4.7.7
Combiprint Configurations
The combi-print configurations can be used for multiple printing of an image of different
sizes or the same size (passport/ID photo) on one sheet of paper. To be able to print
combi-prints the combi-print layouts must be available on the Minilab. Some layouts are
already included in the machine upon delivery. Further combi-print layouts can be created
on a PC/workstation with the AgfaPhoto IP Layout Software and then imported in the
Minilab.
4.7.7.1 Importing Combiprint Layouts
Note
Combi-print layouts can only be imported if the import software on the Minilab has
been activated (see
Note
Only layouts of the AgfaPhoto IP Layout Software 5.08 and higher can be imported. To
use the possibility to change text exposures you need at least Version 5.12 of the
Layout Software, as well as Version 8.xx of the d-lab Software.
350
4-106
2005-05-01 / PN 04092_01
Installing / Activating Software
d-lab.2, d-lab.2plus, netlab.2plus: Operation
in this chapter).
Call up:
Press in this order:
Settings
Machine settings
Combiprint layout
The screen Import combiprint layouts opens.
Applies to d-lab.2/2plus
Select Film mask:
If No filter is selected all the available
layout files will be displayed in the list
Importet Layouts.
If you select a film mask only those layout
files which match the film mask will be
shown.
The file extension of these layouts is ".pas".
Applies to netlab.2plus
Film mask is fixed: No filter
Select a Drive and in the next screen the
Folder, if necessary, in which the layout files
to be imported are stored.
Layout files which can be imported are
shown in the left-hand listing.
AgfaPhoto
Advertisement
Table of Contents
