Remove Paper Dust Applies To D-Lab.2; Transport Unit (Tu) - AgfaPhoto d-lab.2 8060/260 Operation Manual

Table of Contents

Remove Paper Dust

Applies to d-lab.2

Applies to d-lab.2

Special tools

– Vacuum cleaner

– Isopropanol (for plastic-coated rollers, not for rubber rollers)

Isopropyl alcohol is a flammable liquid which may cause irritation of eyes and dry

skin. After maintenance wash your hands with water.

2005-05-01 / PN 04092_01

d-lab.2, d-lab.2plus, netlab.2plus: Operation

Open the Printer front door.

Open the lock of the transport unit (two

Unlock the transport unit and pull it out on

its handle to the front.

Only pull out the transport unit if the LED

shows green!

In case of a paper jam the LED shows red.

To avoid damage in such cases always

pull out the print engine (PE) first!

If the print engine is pulled out the LED

switches to green. The transport unit can

be pulled out.

Lift the top guide plate on the shafts marked

red and fold it up.

Open the guide for the sheet transport.

Remove the paper dust with a vacuum

Clean the sensors with a brush.

Clean the transport rollers: use a dust brush

or a damp cloth (with some water – do not

use Isopropanol; this would damage the

transport rollers).

Close the guide plates again.

Push in the transport unit and lock it.

Close the Printer front door.