Controls On The Minilab; Keys And Pilot Lamps - AgfaPhoto d-lab.2 8060/260 Operation Manual

d-lab.2, d-lab.2plus, netlab.2plus: Operation
2.4

Controls on the Minilab

2.4.1

Keys and Pilot Lamps

1
2
3
G-GG212_2 (Fig. shows d-lab.2)
G-PC713_2 (Fig. shows netlab.2plus)
ON key (1)
If the machine is shut down by the menu command End of work > Shutdown, it remains
in timer mode until the next automatic startup. If you want to work before the timer starts
the machine again automatically, press the ON key to switch on (see
Switching the Machine Off
Furthermore the ON key can be used for a reset while the machine is running (see
Reset via the ON key
in Chapter 7).
Timer lamp (2)
The timer lamp lights up if the machine is in timer mode after shutdown via End of
work > Shutdown.
STOP key (film stop 3; only d-lab.2/2plus))
If a film jam occurs or you assume a film jam, you can press the film stop key to stop the
scanner immediately. Film scanning stops, the order is canceled, and the machine is
reset. The reset popup is shown on the screen with the button Yes. Press this button only
if there is no more paper in the Printer (otherwise this may cause a paper jam).
Problems During Scanning
See
AgfaPhoto
1
2
in this chapter, as well as
in Chapter 7.
General Description, Work Routines and Operation
Applies to d-lab.2/2plus
1 ON key
2 Timer lamp
3 STOP key (film stop key))
Applies to netlab.2plus
1 ON key
2 Timer lamp
End of Work and
Setting the Timer
in Chapter 4).
2005-05-01 / PN 04092_01
2
2-15