Defining Cut Lengths - AgfaPhoto d-lab.2 8060/260 Operation Manual

Table of Contents

Settings and Configurations

* Paper width 3.25 inch (82 mm) and 4.50 inch (114 mm)

As there are only 15 different switch/slide combinations for 16 different paper width, only

15 of the 16 available paper width can be set at the same time. Therefore the same code

has been used in the AgfaPhoto standard for the two above mentioned widths. If you keep

the AgfaPhoto standard only one of these two width can actually be used.

If you want to use both widths, the code of another paper width must be used for one of

these two widths, e.g. the code for paper width 89 mm. But in this case the paper width

89 mm can no longer be used.

Defining Cut Lengths

The defined cut lengths are displayed in pulldown menus when order configurations are

created or edited (see

For an overview of common print formats refer to the tables on the

the print sizes are rounded values. To get the actual size set the value of the cut length

(paper length) in the respective table.

2005-05-01 / PN 04092_01

Defining and Editing Order Configurations

d-lab.2, d-lab.2plus, netlab.2plus: Operation

Press in this order:

Machine settings

The screen Setting of cut lengths opens.

Press New cut length and

enter the cut length (range 89–457 mm).

in this chapter).