Single Sheet Buffer (Sr) And Sheet Bridge (Sb) - AgfaPhoto d-lab.2 8060/260 Operation Manual

d-lab.2, d-lab.2plus, netlab.2plus: Operation

8.4.4.2 Single sheet buffer (SR) and sheet bridge (SB)

Applies to d-lab.2
Special tools
– Vacuum cleaner
– Brush
2
1 SR
dlab2008
AgfaPhoto
SB
3
Open the Printer front door.
Unlock the transport unit (TU) and pull it out
on the telescopic rails.
CAUTION!
Only pull out the transport unit if the LED
shows green!
In case of a paper jam the LED shows red.
To avoid damage in such cases always
pull out the print engine (PE) first!
If the print engine is pulled out the LED
switches to green. The transport unit can
be pulled out.
Pull up the quick-action lock (1), pull the
cover plate of the single sheet buffer a little
to the front and remove it.
Hold the sheet bridge on the right side and
fold it open to the left (3).
Remove the paper dust with a vacuum
cleaner.
Set the sheet bridge back to its initial
position: Mind the lock-in position.
Push the cover plate of the single sheet
buffer into the holding brackets (2) at the
back and fasten it at the front by snapping in
the quick-action lock (1).
Push in the transport unit and lock it.
Close the Printer front door.
2005-05-01 / PN 04092_01
Maintenance
8
8-15