Defining And Editing Paper Configurations - AgfaPhoto d-lab.2 8060/260 Operation Manual

d-lab.2, d-lab.2plus, netlab.2plus: Operation
4.7.1

Defining and Editing Paper Configurations

A paper configuration consists of a paper width and surface. The cut length of the paper is
managed independently. And during setup of a order configuration it is combined with a
paper configuration (see
Note
Paper configurations can only be set up if paper widths and surfaces have been defined
before (see Defining Paper Widths, Surfaces and Cut Lengths
311
AgfaPhoto
Defining and Editing Order Configurations
Settings and Configurations
in this chapter).
in this chapter).
Call up:
Press in this order:
Settings
Print configurations
Paper
The screen Paper configurations opens. The
listing shows paper configurations created before.
Define or edit a configuration:
If you want to define a new paper
configuration:
Press New.
If you want to edit an existing paper
configuration:
Select the paper configuration to be edited
from the list and press Edit.
2005-05-01 / PN 04092_01
4
4-85