Panorama Identification (Only For Color Negatives); Applies Only To D-Lab.2/2Plus; Color / Density Logic (Tfs; Only For Color Negative) - AgfaPhoto d-lab.2 8060/260 Operation Manual

Table of Contents

d-lab.2, d-lab.2plus, netlab.2plus: Operation

4.5.13 Panorama Identification (only for Color Negatives)

TFS detects panorama exposures on 135-type films. The function must be activated to

print panorama sizes correctly. Otherwise the panorama prints have black bars.

TFS: AgfaPhoto Total Film Scanning; (explanation see

in this chapter).

The buttons TFS Color and TFS Density are accessible if the function is active. These

buttons call up further screens in which color and density parameters for the color and

density logic can be changed (see

Setting TFS Density (only for color negative)

We recommend to keep this function always activated, and to switch off only for

special test purposes, e.g. test of the mixed printing.

Certain parts of the logic are effective even if the regulators have not been changed.

Using TFS (only for color

Setting TFS Color (only for color negative)

in this chapter.

Settings and Configurations

Press Panorama identification, to activate

/ deactivate the function.

Press the Color / Density logic button in

the Production balance screen to activate /

deactivate the function.

2005-05-01 / PN 04092_01