Changing The Film Carrier Applies Only To D-Lab.2/2Plus - AgfaPhoto d-lab.2 8060/260 Operation Manual

Production
6.2.3 Changing the Film Carrier
Applies only to d-lab.2/2plus
The corresponding film carrier must be inserted for each film format.
CAUTION!
Only pull out the film carrier when no film is inserted. If you pull on the film
carrier with a film inside, the film will be damaged (exception: single frame
processing in the Manual positioning mode; see
Positioning Mode
dlabr094
After the film carrier has been changed, the pixel correction (PIKO) is performed
automatically. The film carrier must not be pulled out during the PIKO, otherwise errors
Calibrating the Scanner (Pixel Correction, PIKO)
occur (see
6-32 2005-05-01 / PN 04092_01
in this chapter).
d-lab.2, d-lab.2plus, netlab.2plus: Operation
Working with Manual
Remove the film carrier:
Wait until the film is automatically ejected
or eject the film (required in manual
positioning mode: press Eject).
Pull the film carrier out to the front and lift it
off.
Insert the film carrier:
Insert the film carrier in the guides.
Push it in until it locks noticeably.
in Chapter 5).
AgfaPhoto