Default Setting Of Maximum Densities And Calibration Factors - AgfaPhoto d-lab.2 8060/260 Operation Manual

Tests
5.3.4

Default Setting of Maximum Densities and Calibration Factors

Basic settings of maximum densities for Agfacolor Splendix and Agfacolor Sensatis Paper:
Dmax red
Dmax green
Dmax blue
Note
Make sure to start from the basic settings for the used paper. If the wrong basic
settings are used, this may result in distinctive color fringes caused by blooming.
Default settings for calibration factors:
Calibr.fact. red
Calibr.fact. green
Calibr.fact. blue
The default settings are optimized for the use of AgfaPhoto Sensatis and Splendix papers
and AgfaPhoto d-lab chemicals.Therefore we recommend to leave the values for Dmax
and the calibration factors unchanged.
If papers and/or chemicals of other manufacturers are used, the settings can be changed
to improve the calibration for these papers and/or chemicals and thus improve the quality
of the production (see
Balance of the Internal Densitometer
Learn in which cases the settings for maximum densities should be modified further down
When Should the Maximum Densities be Changed?
in this chapter (see
Note
The specified maximum densities (Dmax) refer to the measuring results of the internal
Minilab densitometer.
The internal densitometer has filters deviating from status A.
Therefore the values measured on an external densitometer will usually be different
from the results of the internal densitometer.
5-14 2005-05-01 / PN 04092_01
= 2.3
= 2.2
= 2.05
= 1.03
= 1
= 0.98
Defining New Maximum Densities for a Paper
in this chapter).
d-lab.2, d-lab.2plus, netlab.2plus: Operation
Change Gray
and
).
AgfaPhoto