Table of Contents
Advertisement
d-lab.2, d-lab.2plus, netlab.2plus: Operation
7.8.3
Paper Jam in the Feeder Unit FU
Applies to d-lab.2plus/netlab.2plus
A paper jam in the FU may occur in the following positions:
transfer sheet bridge SB / feeder unit FU
–
crossover in the FU
–
lower paper channel
–
upper paper channel
–
CAUTION!
In case of a paper jam in the feeder unit FU always pull out the print machine PM
first and then the feeder unit FU!
Otherwise paper which may be in the transfer area FU / PM may damage the
machine (paper guides, transport rollers, etc.) or if the paper tears, small paper
pieces may remain in the machine and result errors during production.
A paper jam in the FU is indicated by an illuminated red LED.
Only if the green LED is on the FU can be pulled out (analog to paper magazines)!
Pulling out the print machine PM
1
2
dlab2005
AgfaPhoto
Open the Printer side door.
Open the lock of the print machine: two
levers (1).
Pull out the print machine completely (2).
2005-05-01 / PN 04092_01
Troubleshooting
7
7-31
Advertisement
Table of Contents
