Table of Contents
Advertisement
d-lab.2, d-lab.2plus, netlab.2plus: Operation
7.5.1
Resetting the Machine with the Stop Button
If the machine does not react any more to operator entries, the Stop button on the screen
may be used to trigger a software reset.
Note
(
Applies only to d-lab.2/2plus)
Do not pull out the film carrier during the reset, to avoid errors during pixel correction
Calibrate Scanner (Pixel Correction, PIKO)
(see
AgfaPhoto
Press the Stop button on the screen top
right hand side.
– Applies only to d-lab.2/2plus
Film and paper are moved out;
the active order is aborted.
The reset popup with Yes and No Buttons
–
is displayed.
CAUTION!
Be sure to wait with the confirmation
until the paper transport in the Printer is
empty. Otherwise there is a risk of paper
jam.
Press Yes to initiate a reset.
The main assemblies are initialized.
Information concerning previous orders is
deleted, e.g. reorder lists.
in Chapter 5).
2005-05-01 / PN 04092_01
Troubleshooting
7
7-5
Advertisement
Table of Contents
