Table of Contents
Advertisement
d-lab.2, d-lab.2plus, netlab.2plus: Operation
4.8.4
Defining and Editing Order Configurations of the Reproduction Type
Order configurations of the Reproduction type are used to print image files without
automatic image improvement and without adaptation of the image size to the paper.
Applies only to d-lab.2/2plus
Order configurations of the reproduction type can only be defined for file prints.
The following table offers an overview about the functions which are active or inactive in
the Reproduction mode:
Paper LUT
Color management
Sharpening
Logic calculation for the individual image
Logic calculation over all images of an order
For foreseeable results the pixel size of the image file must be known as it is printed 1:1
(image size) with 400 dpi. Printing is without preview; the configuration cannot be
changed. The image is printed in the center of the paper.
If the image file is
too big with respect to the paper size, the image is cut.
–
to small with respect to the paper size, the image gets white borders.
–
approx. 3 times smaller than the paper size, image processing artifacts may occur.
–
Note
In an existing order configuration the setting for Config. type can no longer be
changed. If you edit an order configuration the Config. type button is inactive.
AgfaPhoto
Repro mode
TFS off
yes
yes
no
yes
no
yes
no
no
no
no
2005-05-01 / PN 04092_01
Settings and Configurations
TFS on
yes
yes
yes
yes
yes
4-123
4
Advertisement
Table of Contents
