Table of Contents
Advertisement
Maintenance
8.4.5.5 Sheet Transfer (ST)
Applies to d-lab.2plus and netlab.2plus
Special tools
– Vacuum cleaner
– Brush
– Isopropanol / water
3
4
G_GG121b
8-28
2005-05-01 / PN 04092_01
2
1
d-lab.2, d-lab.2plus, netlab.2plus: Operation
Open the Printer front door.
Pull the locking lever (1) to the front and
remove the cover (2) of the sheet transfer
(ST).
Lift the Sheet Transfer out of the holder,
holding it by the handle (3), and put it down.
Note
Make sure that the transport belts are not
shifted.
Remove the paper dust with a vacuum
cleaner.
Clean the rollers and transport belts with a
damp lint-free cloth.
Mount the Sheet Transfer again:
Observe the two engaging lugs (4).
Mount the cover of the sheet transfer: insert
the back first, slightly lifting the front. Then
pull the button, top right in the Printer,
lower the front edge of the cover, and
release the button again.
Close the Printer front door.
AgfaPhoto
Advertisement
Table of Contents
