Table of Contents
Advertisement
Tests
5.2.7
Complete New Calibration
If the prints on the different papers in use are too different we recommend to calibrate
again.
The following steps are required (further information see
Printing an MBL Test
After manipulations on the laser module (e.g. repair, exchange, modified adjustments) or
after changing the chemicals a new calibration is recommended. In this case proceed as
follows:
5-8
2005-05-01 / PN 04092_01
in this chapter):
d-lab.2, d-lab.2plus, netlab.2plus: Operation
Printing a PBL Test
and
Print an MBL on master paper.
Directly afterwards print a PBL without laser
point for all papers other than the master
paper.
Print an MBL.
Right afterwards print a PBL with laser point
for all paper configurations starting with the
master paper.
AgfaPhoto
Advertisement
Table of Contents
