Autoprint Without Preview - AgfaPhoto d-lab.2 8060/260 Operation Manual

Production

6.3.1.2 Autoprint without Preview

This is the simplest print mode with the highest throughput.
Preview must be inactive (default setting).
009
While this order is being processed the operator can prepare the next order (see
section of the screen, Next order
of order).
Note
It is not possible to switch to autoprint with preview while an order is running.
6-34 2005-05-01 / PN 04092_01
), or change to another print mode if necessary (after End
d-lab.2, d-lab.2plus, netlab.2plus: Operation
After calling up the Autoprint mode:
Deactivate Preview on, if necessary.
Insert a film / film strip:
It is pulled in, scanned, and printed.
While the order is being processed, the
bottom part of the screen shows information
about the configuration as well as the
process status (Order being processed):
Quantity of the prints printed so far and the
–
total number of prints.
Frame number of the presently printed
–
negative.
FID number (for films IX240).
–
Insert further film strips if they belong to the
same order.
If an order is not automatically finished (see
End of Order (automatic / manual)
chapter) press Order end after film strip.
Upper
in this
AgfaPhoto