Portraits; Border Prints - AgfaPhoto d-lab.2 8060/260 Operation Manual

Production

6.1.9.4 Portraits

Portraits may come out too sharp and thus seem unnatural. Remedy:
Set up a correction configuration with the following settings and add it to the order
–
configuration (this applies then to all pictures of the order for which this configuration
is selected).
or
In the print mode with preview press Image editing > Edit to enter the following
–
settings (applies to the current image):
Area contrast
Detail contrast
Sharpness - edges
Saturation

6.1.9.5 Border Prints

There are two possibilities to print border prints:
1. Border color and width are defined in an order configuration. This settings applies to
all images in an order.
022_dpsi
6-24 2005-05-01 / PN 04092_01
+1
0
–4
–1
d-lab.2, d-lab.2plus, netlab.2plus: Operation
Enter the desired border width in the Order
configuration screen (see
Editing Order Configurations
under Border and select the desired color
under Border color (see
Editing an Order Configuration of the Single
Type
in Chapter 4).
Defining and
in Chapter 4)
Defining and
AgfaPhoto