Table of Contents
Advertisement
d-lab.2, d-lab.2plus, netlab.2plus: Operation
8.4.7
Checking the Solution Levels
Purpose:
To compensate for evaporation (also required with the automatic evaporation
compensation).
CAUTION!
Risk of injury if the wet section cover is unlocked unintentionally or without
paying attention, and then drops back down.
CAUTION!
Observe the safety instructions for the handling of chemicals
Safety Information
(see
AgfaPhoto
in Chapter 3).
The solution levels in the Paper Processor
must be checked and topped up with water
once a week before production is started.
In case of major level drop:
Adjust the water replenishment to the
current requirements.
Have defective level switches replaced by a
service technician.
WARNING!
Risk of fire in case of defective level
switches (overheating of the solution
heaters)!
Defective level switches must be
replaced. They must not be repaired.
Call the service technician to check for
leaks.
2005-05-01 / PN 04092_01
Maintenance
8
8-33
Advertisement
Table of Contents
