Table of Contents
Advertisement
Maintenance
8.7.2
Back Printer: Replacing the Ink Ribbon
When the printing on the back of the prints gets too faded, the ink ribbon must be
replaced.
Special tools
– Ink ribbon cartridge; order number CM+9.8060.LDZF.1
Applies to d-lab.2
2
3
dlab2074
8-58
2005-05-01 / PN 04092_01
1
4
d-lab.2, d-lab.2plus, netlab.2plus: Operation
Open the Printer front door.
Unscrew the locking screw (1, red) of the
lane distributor (LD).
Pull out the lane distributor on the
telescopic rails.
Unscrew the knurled screws (2) and remove
the top cover of the back printer.
Remove the ink ribbon cartridge: remove it
by slightly pressing on both sides (3).
Prepare the new ink ribbon cartridge:
if present remove the foil strip on the ink
ribbon, remove the red protection. The ink
ribbon must be tight in the cartridge; if
necessary tighten by the knob (4) (observe
the direction indicated by the arrow).
Insert the ink ribbon cartridge.
Turn the knob (4) of the cartridge until you
hear the cartridge engage.
Push in the lane distributor (LD) and tighten
the locking screw.
Close the Printer front door.
AgfaPhoto
Advertisement
Table of Contents
