Adjusting The Paper Widths - AgfaPhoto d-lab.2 8060/260 Operation Manual

Table of Contents

6.2.1.3 Adjusting the Paper Widths

The magazine must be adjusted to the paper width to be used, to ensure correct paper

guidance in the magazine (three guides).

2005-05-01 / PN 04092_01

d-lab.2, d-lab.2plus, netlab.2plus: Operation

Open the magazine and remove the core.

Undo the screw for the holder of the paper

guide and remove the holder (see

Illustration

Insert the four fingers of the paper guides in

the notches corresponding to the paper

Ensure that all four fingers are in the correct

Insert the holder again and fasten the screw.

Undo the screws of the guides on the

magazine exit.

Move the guide to the required width and

tighten the screws.

The guides engage if they are inserted