Coding The Paper Magazine; Inserting A Paper Magazine - AgfaPhoto d-lab.2 8060/260 Operation Manual

Table of Contents

6.2.1.5 Coding the Paper Magazine

The code for the inserted paper must be set on the paper magazine. After the magazine is

inserted the machine detects the paper width and surface by the set code.

Do not use two paper magazines with the same code at the same time in the machine!

2005-05-01 / PN 04092_01

d-lab.2, d-lab.2plus, netlab.2plus: Operation

By means of the slides on the magazine the

width and surface of the inserted paper must

be coded as defined in the paper settings

Defining Paper Widths

in Chapter 4).

A machine can only detect the paper

correctly if the magazine is coded

precisely as defined in the paper settings.

Codes that are not matching cause

production problems.

After a paper magazine was inserted the

Minilab determines the paper length. For this,

the paper moves to the cutter and back. To

avoid fogging of the paper both Printer doors

must be closed for this procedure.

Open the door to the paper magazine.

Place the paper magazine on the guide rails

and push it in until it locks audibly.

Close the door to the paper magazine.

The screen shows a popup asking if the

leading paper edge should be cut.