Troubleshooting
7.6
Procedure if an Error Occurs
7.6.1
General Procedure
If then the message Reset successful is displayed, the work can be continued. Otherwise
further actions are required (see
7.6.2
Procedure for Unsolved Errors
062
7-8
2005-05-01 / PN 04092_01
, Procedure for Unsolved Errors
below
d-lab.2, d-lab.2plus, netlab.2plus: Operation
If you know the cause of an error, remove
the error. If an error cause is unknown,
proceed as described below in the paragraph
Procedure for Unsolved Errors
Press Clear if this button is shown.
If required, press the Stop button on the
screen, wait until the paper transport of the
Printer is empty and then press reset.
The screen remains gray during the reset
procedure. Duration approx. 3 minutes.
).
Call up the error list:
All error messages shown in the status line are
saved. They can be called up with the permanent
i button.
Press the
button.
i
Press Error list.
The list shows the error messages along with the
date and time of occurrence.
If an error of the Paper Processor has not
been removed, mark the error message and
press Cancel selection.
Messages of the Printer mainly concern
paper that has to be removed.
Remove the paper (see
Paper Jam
in this chapter).
Deactivate Show all errors so that only
active errors are displayed. All active errors
must be removed and deleted from the list
with Cancel selection.
.
Removing a
AgfaPhoto