Table of Contents
Advertisement
Production
6.1.6.3 Changing the Configuration for the Complete Order
Note
The Change configuration function is not available in the Reorder(only d-lab.2/2plus)
and Network order modes.
Note
Modifications for a running order are not possible. Modifications can only be entered
before an order is started.
Note
The modifications become effective only after the screen called up with Change
configuration (see
be printed with the settings valid prior to the changes.
042_start (Picture shows the start screen for print mode File Print)
The screen Change config. for the order opens. The offered possibilities for changes in
this screen depend on the print mode in which this screen was called up. The meaning of
the changeable settings is explained in Chapter 4,
Configurations
and/or
Defining and Editing Order Configurations
6-16
2005-05-01 / PN 04092_01
following page
) is left again. If the order is started before it will
d-lab.2, d-lab.2plus, netlab.2plus: Operation
After activation of the print mode
(for
d-lab.2/2plus
Autoprint
print, Slide film, or File print
and for netlab.2plus
File print)
Press Change configuration.
Defining and Editing Print
.
Manual positioning
Reorder
,
,
Slide
,
AgfaPhoto
Advertisement
Table of Contents
