Setting The Selector Logic (Only For Color Negatives) - AgfaPhoto d-lab.2 8060/260 Operation Manual

d-lab.2, d-lab.2plus, netlab.2plus: Operation

4.5.17 Setting the Selector Logic (only for Color Negatives)

Applies only to d-lab.2/2plus
Effect
TFS and the selector logic make it possible that negatives, which would result in waste
prints, can be skipped, i.e. will not be printed.
We differentiate four different categories of incorrect exposures, or error categories, which
are detected. The threshold values of these categories can be set individually:
Parameter selects
Selector 1 Underexposed negatives
Selector 2 Overexposed negatives
Selector 3 Fogged or partly blackened
negatives (e.g. light leaking into
an opened camera)
Selector 4 Label detection on the film (Twin
Check label)
Step width: 0.1
Standard setting: 1.0
Note on selector 4
The parameter is set perfectly if a negative with sticker is not printed.
Note
Certain parts of the logic are effective even if the regulators have not been changed.
Note
We recommend to proceed as follows:
Do not change the standard settings.
–
Deactivate the logic only for specific test purposes (e.g. to test mixed printing).
–
AgfaPhoto
Range Description
0.0 - +4.0 Towards 0.0 more underexposed negatives are
printed.
Towards +4.0 fewer underexposed negatives
are printed.
-4.0 - +4.0 Towards –4.0 more overexposed negatives are
printed.
Towards +4.0 fewer overexposed negatives are
printed.
-4.0 - +4.0 Towards –4 more negatives with this problem
are printed.
Towards +4.0 less negatives with this problem
are printed.
-4.0 - +4.0 Towards –4 more negatives with stickers are
printed.
Towards +4.0 less negatives with stickers are
printed.
2005-05-01 / PN 04092_01
Settings and Configurations
4-73
4