Table of Contents
Advertisement
d-lab.2, d-lab.2plus, netlab.2plus: Operation
5.2.3
Daily Calibration with the MBL
In the following print operation the MBL is the means to keep the production stable and
uniform. It is used to compensate for the fluctuations of the system (chemicals, Printer,
etc.).
We recommend to print the MBL directly after machine startup, and additionally once or
twice during the day (every 3 to 4 hours).
For an MBL the master paper must always be inserted.
Note
If selected an MBL is automatically printed upon machine startup (see
Settings / Auto-MBL
in Chapter 4).
However, if an Auto-MBL is to be printed after machine startup, the master paper must
be inserted the night before.
By means of an MBL the master paper is calibrated again. All other papers are then
automatically adapted according to the master correction.
Conditions for a successful print routine:
Only print a PBL for a paper, e.g. because of a new emulsion, if a successful MBL was
–
printed just before. In other words, a PBL is only printed in a calibrated machine.
Observe the rules for calibration of the master paper in case of emulsion changes or
–
changing the master paper as explained in the section
Configuration or Changing the Emulsion (master paper)
AgfaPhoto
Printer
Calibrating a New Paper
in this chapter.
2005-05-01 / PN 04092_01
Tests
5
5-5
Advertisement
Table of Contents
