d-lab.2, d-lab.2plus, netlab.2plus: Operation
Special case:
A paper jam occurs during shutdown of the machine or during reset.
The paper jam is only reported when the machine is started again: during this time, the
Info function cannot be called up.
7.7.2
Paper Jam in the Printer
Applies to d-lab.2
Proceed as follows in case of a paper jam in the Printer part:
The sequence control tries to transport all paper out of the Printer and through the
–
paper processor. In case of an actual mechanical problem this is not possible.
All papers, which are past the location of the paper jam in paper transport direction,
–
are still transported and developed.
All prints in the area of the paper jam must be removed. Watch out for small paper
–
remainders.
Assemblies which have to be pulled out of the Printer to remove jammed paper are
–
not energized.
The Printer will automatically be ready for printing once the operator has removed the
–
jammed papers and cleared the error message or triggered a reset.
AgfaPhoto
Check if paper jam is still reported.
Pull out the sheet transfer (ST).
Check the print drum in the print engine
(PE):
Take out the top guide plate, turn the
print roller forward by hand to transport
out any paper that may still be inside.
2005-05-01 / PN 04092_01
Troubleshooting
7
7-15