Film Mask: File Print - AgfaPhoto d-lab.2 8060/260 Operation Manual

Table of Contents

d-lab.2, d-lab.2plus, netlab.2plus: Operation

4.8.1.2 Film Mask: File Print

Settings and Configurations

Adapt Paper config., Cut length to:

press the button and select the respective

If the selected film mask is the 135FF (full

frame), two buttons each are shown for the

three parameters: for full frame (FF) and for

panorama (P).

The button Adjust to is only displayed with

film mask 135FF.

Press Save or Save as and enter the name.

If the Order configuration screen was

called up with New: Press Config. type and

select Single.

The Film type file print is fixed and cannot

Press PpF (number of prints per frame) and

enter the desired value:

preset value = 1 (range 0 to 999).

Sub-configurations (Indexprint, Backprint,

Correction, Autosave, Front print): press

the button and select the respective sub-

configuration from the list or set to Off.

If border prints are to be printed:

Press Border and enter the required

Possible values: 4–60 mm

Presetting: 0 (for borderless).

Press Border color and select the desired

Press Paper config. and select the

respective configuration.

Press Cut length and select the respective

2005-05-01 / PN 04092_01