Table of Contents
Advertisement
Troubleshooting
7.6.4
Image Processing Errors
It is possible that several pictures could not be printed. However, only the last image is
indicated in this case.
Error by incorrect selection of the adaptation type for file print.
022_dpsi
Remedy: select correct adaptation (see
Carrier File print
in Chapter 4):
Fit image to paper
–
(presetting) The complete digital image is printed; in case of an image with different
aspect ratio than the paper, the print has a white border on two sides.
− Fill print size
A center cropping of the digital image is printed without a border; part of the original
image is lost if the digital image has another aspect ratio than the paper.
Adjust: Shorter side or
–
Adjust: Longer side
The original image remains the same, the cut length is variable. One side of the digital
image is adjusted to the paper width: either shorter side or longer side.
If Fill print size is selected, the aspect ratio of the frame must almost correspond to that
of the print size. In case of very big differences, the error message Parameter range
violation is displayed. The image can then only be printed with Fit image to paper.
7-10
2005-05-01 / PN 04092_01
Order Configurations of the Single Type / Film
d-lab.2, d-lab.2plus, netlab.2plus: Operation
Press Clear.
AgfaPhoto
Advertisement
Table of Contents
