Table of Contents
Advertisement
General Description, Work Routines and Operation
2.6.4
Popup Windows
Popup windows are opened in the active screen if a confirmation or an action by the
operator is required:
Reset popup (only d-lab.2/2plus)
–
Comes up after the film stop key (STOP key on the scanner housing) has been pressed.
Problems During Scanning
(See
Error popup
–
Appears in case of wrong operator entries, consistency errors and system errors. These
errors must be repaired immediately to be able to continue working (see
Error Messages
in Chapter 7).
If several errors occur at the same time, the error popup windows shows arrow buttons
which allow scrolling through the messages.
054
Warning popup
–
Comes up if data could be lost, e.g. if changes were made in a screen and the screen is
then left with Clear.
Info popup
–
Operator prompting; queries when changing to a different screen, indication of still
running processes.
2-32
2005-05-01 / PN 04092_01
in Chapter 7.)
d-lab.2, d-lab.2plus, netlab.2plus: Operation
Display of
AgfaPhoto
Advertisement
Table of Contents
