Table of Contents
Advertisement
Settings and Configurations
4.4.7
Paper Processor Settings
The following settings and calibrations must be made for the Paper Processor:
Setup of replenishment rates
–
Setup of temperatures for chemical solutions / calibration of temperature sensors
–
Calibration of water pumps
–
4.4.7.1 Setting the Replenishment Rates
The replenishment depends on the throughput, i.e. it depends on the actually processed
paper per day. To keep the production consistent, more chemicals and water must be
replenished with a low throughput rate than with a high throughput rate. Thereby we
differentiate between normal, increased, and maximum replenishment. This means that
the normal replenishment rates are increased by the entered factor for the increased or
the maximum replenishment rate. The software calculates every day the average
throughput of the last 5 days and sets the appropriate replenishment automatically. In
case of less than 10 m
2
the maximum replenishment are automatically activated (these throughput thresholds are
preset default values; they can be changed if necessary; see
Chapter 9).
If the machine is put in operation for the first time or if it was switched off for several
days, an initial value must be entered (see
CAUTION!
The preset reference values are adjusted to AgfaPhoto chemicals (Easy Box 110)
and AgfaPhoto paper. Therefore we recommend to change the set values only if
these value fail to produce optimum print results.
If necessary the value can be reset to default.
Note
The replenishment rates for the individual solutions DEV (developer), BX (bleach-fix),
and STB (stabilizer) cannot be changed separately. If the replenishment rate is changed
for one solution, the other two solutions are automatically changed by the same ratio.
4-34
2005-05-01 / PN 04092_01
throughput the increased replenishment and for less than 5 m
next page
d-lab.2, d-lab.2plus, netlab.2plus: Operation
Paper Processor
section
).
2
in
AgfaPhoto
Advertisement
Table of Contents
