Table of Contents
Advertisement
d-lab.2, d-lab.2plus, netlab.2plus: Operation
8.4.5.2 Sheet Stocker (SR) and Sheet Bridge (SB)
Applies to d-lab.2plus and netlab.2plus
Special tools
– Vacuum cleaner
– Brush
3
2
1
G_SG104
AgfaPhoto
Open the Printer front door.
Unlock the feeder unit (FU) and pull it out on
the telescopic rails.
CAUTION!
Only pull out the feeder unit if the LED
shows green!
In case of a paper jam the LED shows red.
To avoid damage always pull out the print
machine first in such cases!
If the print machine is pulled out the LED
switches to green. The feeder unit can be
pulled out.
Pull up the quick-action lock (1), pull the
cover plate of the sheet stocker (SR) a little
to the front and remove it.
Hold the sheet bridge (SB) by the red handle
on the right and fold it to the left (3).
Remove the paper dust with a vacuum
cleaner.
Set the sheet bridge back to its initial
position: mind the lock-in position.
Push the cover plate of the sheet stocker
into the holding brackets (2) at the back and
fasten it at the front by snapping in the
quick-action lock (1).
Push in the feeder unit and lock it.
Close the Printer front door.
2005-05-01 / PN 04092_01
Maintenance
8
8-23
Advertisement
Table of Contents
