Table of Contents
Advertisement
d-lab.2, d-lab.2plus, netlab.2plus: Operation
4.5.18 Setting Color and DX Corrections (for Color Negatives)
Applies only to d-lab.2/2plus
The Color corrections screen (see
corrections. They apply to all film types.
Individual corrections can be entered additionally for each defined DX code in the
DX Configurations screen (see
saved in the DX configurations (e.g. if certain films are not printed with satisfying results
in spite of TFS, or if they do not correspond to the general taste in a country). During
printing the individual corrections are added to the general corrections when the
respective DX code is detected.
Separate inputs for neutral, overexposures and underexposures are possible in both
screens.
Note
The corrections are immediately effective and not only after a restart.
Note
The changes made for color and density corrections are added to the general
corrections of the basic balance. Therefore they do not show in the backprint.
4.5.18.1 Color Corrections
Applies only to d-lab.2/2plus
101
AgfaPhoto
below
for activation) allows the input of general
next page
for activation). These corrections can be
Settings and Configurations
Call up:
Press the Color correction button in the
Production balance screen.
The Color corrections screen opens. In this
screen color and density values applying to all
films can be entered.
Enter correction values for neutral exposure,
overexposure and underexposure:
Press left or right Arrow key for the required
parameter to increase or decrease the value.
2005-05-01 / PN 04092_01
4
4-75
Advertisement
Table of Contents
