Panasonic FP-XH M8N16PD User Manual page 486

Specifications
Offset
Name
address
Synchronous master axis
H2BA
information monitor of
axis 6
Synchronous output
H2BB function selection status
monitor of axis 6
Synchronous master axis
H2BC information monitor of
(virtual) axis 7
Synchronous output
H2BD function selection status
monitor of (virtual) axis 7
Synchronous master axis
H2BE information monitor of
(virtual) axis 8
Synchronous output
H2BF function selection status
monitor of (virtual) axis 8
 System operation setting area
Offset
Name
address
H2C0
Reserved for system
-H388
Deceleration stop
H389
operation
H38A
Reserved for system
-H38F
26-30
Default Description
HF Refer to the description for the axis 1
H0 Refer to the description for the axis 1
HF Refer to the description for the axis 1
H0 Refer to the description for the axis 1
HF Refer to the description for the axis 1
H0 Refer to the description for the axis 1
Default Description
－ －
Specify the operation when setting the deceleration stop request
signal to "Active" (from OFF to ON).
0: Deceleration stop
When performing the repeat operation, stops after reaching E
point that is targeted for the repeat operation.
1: Pause
・Performs the deceleration stop, and restarts the positioning
operation when turning "Deceleration stop request signal" to
OFF from ON.
K0
・Also, performs the same operation as the deceleration stop in
all states except during the positioning operation.
・When performing the repeat operation, stops after reaching E
point that is targeted for the repeat operation, and restarts the
positioning operation when turning "Deceleration stop request
signal" to OFF from ON.
・If a system stop or emergency stop is executed while the
positioning unit is paused, the pause state will be canceled and
the operation will not restart with the deceleration stop request
signal is canceled (turned OFF).
－ －