Setting Procedures And Operations (Ratio Specification Method) - Panasonic FP-XH M8N16PD User Manual

17.6.3 Setting Procedures and Operations (Ratio Specification Method)

 Setting procedures and operations of ratio specification method (Override)
When setting the ratio specification, the command speed is immediately reflected in the
specified ratio once the "Ratio specification" in the shared memory is changed.
f
200,000pps
100,000pps
50,000pps
100(%)
Ratio specification
(Note 1) The acceleration time to the change speed and the deceleration time from the change speed follows the
setting values of the active table.
(Note 2) The movement amount does not change when the speed change is performed.
 Setting parameters of ratio specification method
The following parameters are used in the target speed change function of the ratio
specification method.
Positioning operation change setting area (Positioning memory area No. 5)
Offset
address Name
(Hex)
Positioning speed
change
H0 Ratio
specification
(Override)
200(%) 50(%)
Default Description
Area for setting the change ratio (override) to the command
speed for the positioning speed change. The speed change
request by I/O is not necessary, and the change becomes valid
K100
when the set value (ratio) is set.
1 to 300 (%)
17.6 Target Speed Change Function
100(%)
t
17-15