Table of Contents
Advertisement
Setting of Position Control Parameters
9.3 Synchronous Parameter / Cam Pattern Settings
9.3.1 Synchronization parameter settings
Parameters required for synchronous control are set via the Configurator PM7. The following
steps are performed with the Configurator PM7 that has been started as a premise.
PROCEDURE
1. Select "Axis Setting"→"Synchronization Parameter Setting" from the menu
bar.
The dialog box of "Synchronization Parameter Settings" appears.
2. Set the necessary parameters according to the purpose and press [OK].
3. Select "File" > "Apply Setting" from the menu bar.
The parameters set in Configurator PM7 are applied as the project data being
edited.
KEY POINTS
•
In the case of synchronous control, basic parameters related to I/O operate
according to "9.2 Parameter settings".
•
Closing the window with the X mark during editing the "Synchronous
parameter settings" dialog cancels and stops the operation.
•
To save parameters as a file, select "File" > "Save Setting".
9-8
Advertisement
Table of Contents
