Table of Contents
Advertisement
Transfer to Unit and
Commissioning
KEY POINTS
•
For the positioning operation, the setting data should be downloaded to the
control unit in advance. The operations after the starting table number vary
depending on operation patterns.
•
The positioning operation of the interpolation group starts and stops the
axis with the smalles number in the group. In the case of the tool operation
function, the positioning operation starts by pressing the "Operate" button
of any axes, however, a warning message is displayed when the "Operate"
button other than that for the smallest axis number is pressed.
This dialog box cannot be closed during the operation.
•
•
When conditions are changed during the tool operation, the positioning
memory will be updated temporarily and the operation will be performed,
however, the changed conditions will not be reflected in the configuration
data written in the control unit. Therefore, when the mode is changed to the
RUN mode again, the unit will start based on the configuration data
downloaded to the control unit.
10-18
Advertisement
Table of Contents
