Panasonic FP-XH M8N16PD User Manual page 524

Specifications
WR903 (specified in word)
Relay
number
R9030 Unused
R9031 Unused
R9032
COM1 port operation mode flag
(R9139)
R9033 Print instruction executing flag
Program editing flag in RUN
R9034
mode
R9035 Unused
R9036 Unused
R9037 COM1 port communication error
(R9138) flag
Reception completion flag for
R9038
COM1 port general-purpose
(R913A)
communication
Sending completion flag for
R9039
COM1 port general-purpose
(R913B)
communication
R903A Unused
R903B Unused
R903C Unused
R903D Unused
Reception completion flag for
R903E
COM0 port general-purpose
(R9132)
communication
Sending completion flag for
R903F
COM0 port general-purpose
(R9133)
communication
(Note 1): R9030 - R903F will change even during one scanning cycle. In addition, the special internal relay in
parentheses is also allocated the same function.
26-68
Name
When using the general communication function, it is ON.
When using a function outside of the general communication
function, it is OFF.
OFF: not executed.
ON: executing
The special internal relay that is ON only at the first scan
cycle after program editing completed in RUN mode.
When performing data communication, if a transmission error
occurs, it is ON.
When requesting for sending via the F159 (MTRN)
instruction, it is OFF.
For general communication, if the end character is received, it
is ON.
For general-purpose communication, if end the transmission,
it is ON.
For general-purpose communication, if transmitting is
required, it is OFF.
For general-purpose communication, if the end character is
received, it is ON.
For general-purpose communication, if end the transmission,
it is ON.
For general-purpose communication, if transmitting is
required, it is OFF.
Description