Table of Contents
Advertisement
Setting of Position Control Parameters
9.2 Parameter settings
9.2.1 Parameter Settings in Configurator PM7
The parameters common to various controls such as command unit, origin input, logic of limit
input and stop time, and the parameters relating to home return and JOG operation are
assigned by Configurator PM7. The following steps are performed with the Configurator PM7
that has been started as a premise.
PROCEDURE
1. Select "Axis Settings"→"Parameter Settings" from the menu bar.
The dialog box of "Parameter Settings" appears.
2. Set the necessary parameters according to the purpose and press [OK].
After displaying the message "Updating data display", the screen returns to the
base screen of Configurator PM7.
3. Select "File"→"Apply Settings" from the menu bar.
The parameters set in Configurator PM7 are applied as the project data being
edited.
KEY POINTS
•
Closing the window with the X mark during editing the "Parameter settings"
dialog cancels and stops the operation.
•
To save parameters as a file, select "File" > "Save Setting".
9-4
Advertisement
Table of Contents
