Wiring of Power Supply and General-purpose I/O Parts
5.3 Wiring of Input and Output
5.3.1 Precautions Regarding Input and Output Wirings
Wiring location
The input wire, output wire and power line shall be separated from each other, try to keep
their distance when wiring.
wire, output wire, power line and high-voltage line shall be separated by at least 100 mm.
Wire selection
When wiring the input line and output line, select the wire diameter according to the current
capacity.
Power supply
Switch off the PLC power supply before wiring. The control units, expansion units and all
cassettes shall be connected with the power supply switched off. If you make the connection
with the power supply switched on, a failure or malfunction may occur.
5-8
Do not put them in the same conduit or tie them up.
The input