Table of Contents
Advertisement
Contact
Target
allocation
axis
X1270
Axis 1
X1271
Axis 2
X1272
Axis 3
X1273
Axis 4
X1274
Axis 5
X1275
Axis 6
Axis 7
X1276
(virtual)
Axis 8
X1277
(virtual)
X1278
-
-X127F
X1280
Axis 1
X1281
Axis 2
X1282
Axis 3
X1283
Axis 4
X1284
Axis 5
X1285
Axis 6
Axis 7
X1286
(virtual)
Axis 8
X1287
(virtual)
X1288
-
-X128F
X1290
-
-X129F
X1300
-
-X130F
X1310
Axis 1
X1311
Axis 2
X1312
Axis 3
X1313
Axis 4
X1314
Axis 5
X1315
Axis 6
Axis 7
X1316
(virtual)
Axis 8
X1317
(virtual)
X1318
-
-X131F
(Note 1): When using the virtual axes, the I/O numbers allocated vary according to the number of virtual axes.
When selecting virtual 1st
axis
When selecting virtual 1st
and 2nd axes
3.4 Detailed I/O Information of Motion Control Part
Name
Description
Changes synchronous settings in the unit with the synchronous
setting request contact (Y1270 to Y1277) turned ON after
Synchronous
changing the settings of synchronous control with the program.
setting done
The contact turns ON upon completion of the setting changes.
This contanct turns OFF with the synchronous setting request
contact (Y1270 to Y1277) turned OFF.
-
-
Turns ON when the synchronous operation of the positioning unit
Synchronous
is canceled with the synchronous setting cancel request contact
cancel active
(Y1280 to Y1287) turned ON.
announciation
The synchronous operation axes cannot be executed if this
contact is ON for the axes.
-
-
-
-
-
-
Makes gear ratio changes with the slave axis gear ratio change
Slave axis gear
request contact (Y1310 to Y1317).
ratio change
The contact for the corresponding axis tirms ON after the gear
annunciation
ratio is changed.
-
-
The I/O number of "Axis 8 (virtual)" in the above table is allocated to "virtual
1st axis".
The I/O number of "Axis 7 (virtual)" in the above table is allocated to "virtual
1st axis".
The I/O number of "Axis 8 (virtual)" in the above table is allocated to "virtual
2nd axis".
3-17
Advertisement
Table of Contents
