Table of Contents
Advertisement
10.4.2 Servo ON/OFF with Tool Operation Function
The following procedure is explained on the condition that the Configurator PM7 has already
started.
PROCEDURE
1. Select "Online" → "Tool Operation" from the menu bar.
The "Tool Operation" dialog box is displayed.
2. Select "Servo ON/OFF" from the "Tool Operation" dialog box.
The "Servo ON/OFF" dialog box is displayed.
3. Press the [ON/OFF] button of any axis.
The Servo ON/Servo OFF status is switched.
4. Confirm the Servo ON/OFF of any axis and press the [Close] button.
It returns to the "Tool Operation" dialog box.
KEY POINTS
•
If the servo ON/OFF has been controlled using ladder programs, the servo-
lock or servo-free state before the start of the tool operation is kept and the
operation shifts to the tool operation.
The servo-lock or servo-free state before the completion will be kept even
•
after finishing the tool operation mode.
10.4 Tool Operation
10-11
Advertisement
Table of Contents
