Draytek Vigor2762 series User Manual page 647

Syntax Syntax
wl set8021x –t [0/1]
wl set8021x –v
Syntax Description Syntax Description
Parameter
-t
-v
Example
Example
> wl set8021x -t 1
% <Note> Please restart wireless after you set the parameters.
> wl set8021x -v
802.1X type is : Local 802.1X
>
Telnet Command:
Telnet Command:
This command allows you to set the white list of WAN IP addresses/Subnets, that the magic
packet from these IP addresses/Subnets will be eligible to pass through NAT and wake up
the LAN client. You also need to set NAT rule for LAN client.
Syntax
Syntax
wol up [MAC Address]/[IP Address]
wol fromWan [on/off/any]
wol fromWan_Setting [idx][ip address][mask]
Syntax Description
Syntax Description
Parameter
MAC Address
IP address
on/off/any
[idx][ip address] [mask]
Vigor2762 Series User's Guide
Description
Specify the type (external or internal) of wireless authentication
server.
0 – Indicate the external RADIUS server.
1- Indicate the local 802.1x server.
View the settings of 802.1x.
wol
wol
Description
It means the MAC address of the host.
It means the LAN IP address of the host. If you want to wake up
LAN host by using IP address, be sure that that IP address has been
bound with the MAC address (IP BindMAC).
It means to enable or disable the function of WOL from WAN.
on: enable
off: disable
any: It means any source IP address can pass through NAT and
wake up the LAN client.
This command will allow the user to choose whether WoL packets
can be passed from the Internet to the LAN network from a
specific WAN interface.
It means the index number (from 1 to 4).
These commands will allow the user to configure the LAN clients
that the user may wake up from the Internet through the use of
the WoL packet.
ip address - It means the WAN IP address.
mask - It means the mask of the IP address.
637