Draytek Vigor2762 series User Manual page 436

VIII-5 Checking If
VIII-5 Checking If
If WAN connection cannot be up, check if the LEDs (according to the LED explanations listed
on section I-1) are correct or not. If the LEDs are off, please:

Change the Physical Type from Auto negotiation to other values (e.g., 100M full
duplex).

Next, change the physical type of modem (e.g., DSL) offered by ISP with the same value
configured in Vigor router. Check if the LEDs on Vigor router are on or not.

If not, please install an additional switch for connecting both Vigor router and the
modem offered by ISP. Then, check if the LEDs on Vigor router are on or not.

If the problem of LEDs cannot be solved by the above measures, please contact with the
nearest reseller, or send an e-mail to DrayTek FAE for technical support.

Check if the settings offered by ISP are configured well or not.
When the LEDs are on and correct, yet the WAN connection still cannot be up, please:

Open WAN >> Internet Access page and then check whether the ISP settings are set
correctly. Click Details Page of WAN1~WAN4 to review the settings that you configured
previously.
426
the ISP Settings
the ISP Settings
are OK or N ot
are OK or N ot
Vigor2762 Series User's Guide