Draytek Vigor2762 series User Manual page 629

Syntax Description Syntax Description
Parameter
on/off
Example
Example
> vpn pass2nat on
% Packets would go through by NAT when VPN disconnect!!
Telnet Command:
Telnet Command:
This command allows users to build VPN between clients via virtual subnet.
vpn sameSubnet -i [value]
vpn sameSubnet –E [0/1]
vpn sameSubnet –e[value]
vpn sameSubnet-I [xxx.xxx.xxx.xxx]
vpn sameSubnet -o [add/del]
vpn sameSubnet -v
Syntax Description
Syntax Description
Parameter
-i [value]
–E [0/1]]
-e [value]
-I [xxx.xxx.xxx.xxx]
-v
Example
Example
> vpn sameS
> vpn sameS -v
IPsec with the same subnet:
VPN profile 1 enable,
% translated LAN1 to Virtual subnet: 10.10.10.0
Telnet Command:
Telnet Command:
This command allows users to adjust the size of PPP LCP MRU. It is used for specific
network.
wan ppp_mru <WAN interface number> <MRU size >
Vigor2762 Series User's Guide
Description
on – the packets can pass through NAT.
off – the packets cannot pass through NAT.
vpn sameSubnet
vpn sameSubnet
Description
Specify the index number of VPN profile.
Enable or disable the IPsec with the same subnet.
1 – enable.
0 – disable.
Translate specified LAN to virtual subnet.
1 – LAN1
2 – LAN2
3 – LAN3 ...
Set the virtual subnet (e.g., 172.16.3.250).
Display current status of virtual subnet.
-i 1 -e 1 -E 1 -e 1 -I 10.10.10.0 -o add
wan ppp_mru
wan ppp_mru
619